Home & Living

Not sure where to put carbon monoxide detectors?

Where to put carbon monoxide detectors comes down to two CPSC recommendations: an alarm on each level of the home and an alarm outside sleeping areas.

Photo by Jorge Fernández Salas on Unsplash
In this guide

Where to put carbon monoxide detectors comes down to two CPSC recommendations: an alarm on each level of the home and an alarm outside sleeping areas.

The same CPSC page adds one exception. CO alarms should not go in attics or basements unless those spaces include a sleeping area, so a basement guest room changes the count and a storage-only attic does not. Your state or city may require more than the CPSC recommends, so check the alarm's manual for any placement and mounting instructions.

What the CPSC says about where CO alarms go

The CPSC's consumer page on CO alarms, as of October 2026, says alarms "should be installed on each level of the home and outside sleeping areas." The same page says they "should not be installed in attics or basements unless they include a sleeping area."

Read together, the two sentences mean that each level of the home gets an alarm, with an alarm outside sleeping areas, and an attic or basement joins the list only when someone sleeps there. The CPSC's Carbon Monoxide Information Center gives households the same idea in one line: "Install one on every level and outside sleeping areas at home and check the batteries regularly."

An older joint flyer from the CPSC and NFPA, dated 2014, uses slightly different words. It says to install alarms "in a central location outside each separate sleeping area, on every level of the home, and in other locations as required by laws, codes, or standards." Under that wording, a house with bedrooms in separate wings may need separate alarms; confirm with the applicable code and the alarm's instructions. The flyer also does not repeat the basement exception, which is one reason to check your local code before deciding a basement needs nothing.

The CPSC frames all of this as a recommendation. According to a National Conference of State Legislatures (NCSL) summary that was not independently verified here, rules vary by state and locality; whether an alarm is required by law in your particular home is a question for your state or local housing department, covered further down.

According to a 2017 NFPA presentation, NFPA's Standards Council approved moving the CO alarm requirements from NFPA 720 into NFPA 72, starting with the 2019 edition, and withdrawing NFPA 720. If a guide you are reading treats NFPA 720 as current, check when it was written.

This guide is general information, not medical advice. If you have concerns about your child’s health or safety, consult a pediatrician or another qualified professional. Follow product labels and manufacturer instructions. In an emergency in the United States, call 911. Elsewhere, use your local emergency number.

a light bulb on a table
Photo by Yosuke Ota on Unsplash

How many alarms a two-story home with a basement needs

Counting by the CPSC wording, a two-story home with bedrooms upstairs and a basement where nobody sleeps comes to two alarms in this example: one on the main floor and one in the upstairs hallway outside the bedrooms. Put a bedroom in the basement and the example rises to three.

The count is only an example for this layout. Your floor plan, your local code, and the 2014 flyer's "every level" wording can all push the number up.

Home layout Levels Sleeping areas Alarms per CPSC wording (example) Notes
One-story, all bedrooms off one hallway 1 1 1 Example only; check local code and the alarm's manual
One-story, bedrooms at opposite ends 1 2 2 One outside each separate sleeping area
Two-story, bedrooms upstairs, no basement 2 1 2 Main floor plus the upstairs hallway
Two-story, bedrooms upstairs, basement with no bedroom 3 1 2 The CPSC page skips basements without a sleeping area; check local code
Two-story, bedrooms upstairs, basement bedroom 3 2 3 The basement now includes a sleeping area
Two-story, primary bedroom downstairs, kids' rooms upstairs 2 2 2 Each alarm sits outside a sleeping area on its own level

The one-story row with bedrooms at opposite ends is the easiest to undercount. In a ranch house with the primary suite on one side and the kids' rooms on the other, a single alarm in the kids' hallway leaves the other sleeping area without one outside its door. The flyer's "each separate sleeping area" wording fits exactly that layout.

Bedrooms also move as kids grow. A teenager who takes over the finished attic, a toddler whose playroom in the basement becomes a bedroom, or a grandparent who sleeps in the lower-level guest room over the holidays each turns a space the CPSC page would skip into a sleeping area. When a room changes use, count again.

A finished attic follows the same logic as a basement. If nobody sleeps up there, the CPSC wording leaves it off the list. If it becomes a bedroom, it gets an alarm outside the sleeping area like any other floor.

Where not to put a carbon monoxide detector

The clearest restriction in the CPSC wording concerns attics and basements that do not include a sleeping area. Beyond that, the CPSC lines quoted in this guide do not set the placement details people most often search for: how high on the wall, how close to a furnace or water heater, and whether a garage needs its own alarm.

Those details live in the manual for the alarm you own. If the paper manual is long gone, use the alarm's identifying information to look for the manufacturer's instructions.

A spot that works for a smoke alarm is not automatically the right spot for a CO alarm, and the reverse is also true. For a combination unit that detects both, consult its supplied instructions rather than combining two sets of rules from memory.

The same goes for the advice that circulates in comment threads and older how-to posts. If a placement rule is not in the CPSC wording, your local code, or the alarm's manual, verify it against the current local code and the alarm's instructions before drilling a hole.

What your state or city code may add

An NCSL summary not independently verified here indicates that rules vary by state and locality, and state or local codes may require CO alarms in more places, or in more kinds of homes, than the CPSC recommendation covers. The 2014 CPSC and NFPA flyer leaves room for this with its line about "other locations as required by laws, codes, or standards."

According to a summary from the National Conference of State Legislatures (NCSL), last updated in September 2025 and not independently verified here, states vary in their requirements for CO alarm installation in homes. The summary indicates that rules may depend on the type of dwelling, whether the home has fuel-burning equipment, or events such as a sale or a renovation. NCSL's table is a secondary summary, not the text of each law, so treat it as a starting point.

Because requirements may vary, check your state's or city's housing department for the rules that apply to your home. NCSL points homeowners, landlords, and tenants with questions about local CO alarm requirements to their state or local housing department. Start with the department's official website to look for the current rule.

If you rent, the same housing department is the place to look for what the landlord is responsible for and what falls to the tenant. If you are buying or selling, ask the agent or inspector which local rule applies before closing, since NCSL's summary indicates that some requirements may be tied to a sale.

Testing monthly and replacing batteries once a year

The CPSC recommends testing smoke and CO alarms monthly and replacing their batteries once a year. That advice applies to every alarm in the house, including the ones in the basement bedroom and the upstairs hallway.

For the monthly test, use the method in the alarm's manual. For convenience, consider tying it to a date the household already keeps, like the first weekend of the month. Older kids can take a turn pressing the test button with a parent and marking the month off on the family calendar.

The yearly recommendation applies to the batteries. The CPSC advice cited here does not give a replacement age for the whole CO alarm. For that, check the manufacturer's instructions for unit replacement information and any end-of-life signal. Consider writing the installation date on the back of the alarm for future reference.

Why heating season is the time to check

During heating season, households may begin using fuel-burning equipment more often. The U.S. Fire Administration's carbon monoxide page, updated September 2026, says CO poisoning can occur when a fuel-burning appliance or machine, "such as a furnace, heater or generator, is not working or vented properly."

The CPSC's Carbon Monoxide Information Center also lists a poster titled "Practice Fire & Carbon Monoxide (CO) Safety During Cold Weather" alongside its CO alarm guidance. A furnace that has been off since spring, a heater pulled out of the closet, and a generator that only runs during a winter storm are the kinds of equipment the USFA page names.

That makes the first cold week a good time to walk the house with the table above in mind. Count the levels, count the sleeping areas, and look for any room whose use changed since last winter. If the count comes up short, look first at a second sleeping area or at a basement or attic bedroom that was added during the year.

During a winter outage, some households use a generator or an alternative heat source. Our guide to the first hour of a power outage with kids covers what to do before the lights come back.

Checking alarms fits with other yearly home safety routines. For one of them, see our guide to a fire escape plan for kids.

For storm preparation, see our winter storm checklist for families.

Start with the bedroom doors. Stand in each doorway, look down the hall, and see whether there is a CO alarm between that room and the rest of the house.

Frequently asked questions

How many carbon monoxide detectors does a home need?
The CPSC recommends one on each level of the home and one outside sleeping areas, with no alarm in an attic or basement unless it includes a sleeping area. In practice the count depends on how many floors you live on and how many separate sleeping areas the home has. Your state or local code may require more.
Should a carbon monoxide detector be placed high or low?
The CPSC wording on placement does not set a mounting height. Follow any placement instructions supplied for the alarm you own.
Can I put a carbon monoxide detector next to my furnace?
The CPSC placement wording does not give a distance from a furnace or other fuel-burning appliance. Check the alarm's manual for any guidance on distance from the appliance. The CPSC wording focuses on each level of the home and the area outside sleeping areas.
Should a CO detector be installed in the garage?
The CPSC recommendation does not address garages. Check the alarm's manual and your state or local housing department, since local codes may require alarms in additional locations beyond the CPSC recommendation.

Sources

All sources checked on October 31, 2026.

All Home & Living guides →